Please God HELP ME!!!

[psychoballer07]

I really hope someone can help me with this....every time i switch my gun to live mode, it wont shoot. i degassed it and there isnt even that little click. so i took the board out and cleaned the sensors just to make sure, and it still would not shoot. i dont know if my opto thingy is broken or is there an easier sollution? i know its not the trigger because the sollenoid still wont click when i take the board out of the frameand just pull the leaf. any help would be greatly appreciated because i have a real big game on sunday.

[Vantage_TeS]

Make sure your wires are connected up ok, plugged into the right spots. Make sure the wires did not get pinched.

Remove the sight rail. Press the override button on the noid. Does it shoot? If so, the noid is ok.

Check other modes (cops on and off).

[Emmit]

as mentioned check that the wires between the plug on the marker and the solenoid body are good, a teammate of mine had a wire come out of the solenoid and it was doing this. Easy replacement, and you can get the new solenoid from the sponsors or send it in to them.

Worse case scenario is damage to the board that will require a board swap.

Have you verified a good charge on the marker and that all plugs are in the right ports?

[acoenfam1]

Both of these sound like good places to start.

[psychoballer07]

the marker is fully charged, the wires are plugged in and in the right spots, and i pushed the little orange button on the noid and it shoots. when i take the board ouit of the frame now and wiggle the leaf it will shoot for like 5 seconds, but when i put it back in the frame it will stop again.

[thog94]

Is the wire to the noid pinched at all?

[Vantage_TeS]

So when the board is out you can make it shoot, but when you put it back in, it doesn't. When its in, does it not shoot due to to the trigger?

Also have you bent the lead spring at all?

Otherwise it will have to be wiring (something wiggles or pushes out of place when you put it back in).

[acoenfam1]

Sounds like your trigger may be set to short. If you adjusted it and didn't locktite it the set screws can and do move.

[psychoballer07]

i checked the trigger and all the wires, i bent the leaf a few months ago and up until last night it worked great, i played with it all day and when i went to clean it it went kaput...thanks for all the help but i gave up and its on its way to Ken right now

[Assault]

I just fixed my team mates marker with the same problem. It was the wires to the solenoid, had broken the solder inside the actual solenoid where the wires joined to it. If you had moved the solenoid wiring or solenoid itself when you went to clean it then it may have been the cause. I just took the wire cover off the noid and re-soldered it, properley. Works good now.

[ricecrispi]

sounds like you ripe out a wire from noid. Happens when you clean out a gun and let the trigger frame or board hang from the wires. Did you do any work on the ram stroke??

check the plugs and in safe mode and pull trigger and see if lcd turns on. If it turns on the board is running and probably the wires in the body needed to be checked.
If the creen doesn't turned on wipe out a backup on sunday and send out the gun to MT.

Edit
Also have the lcd set to turn on. I think thats the hud option but im no expert.