Low pressure Ir3??

[azyndevil]

Hey guys im still new to angels and i have a quick question. Can u make the Ir3 operate at a lower pressure? I realli want to kno cause low pressure ir3 would be great! I think i would need to change the regulator, just help me out on that. Also on a side note, i checked my trigger last nite and i saw that it didnt have a cops sensor or rod....( i bought it used on ebay) i was always wondering y it didnt pass the drop test. How much can i buy one and can i install it without messing nethin up thanks again guyz

[Emmit]

COPS is easy to replace and relatively cheap as well. The sponsors all have the necessary parts. Just be sure to be careful running the wires down the channel (a little sticky tac works great at keeping the wires in the channel).

As for lowering the operating pressures....not really. You'd have to bore out the internal passages to allow for a higher volume of air to pass through the marker to do so.

[Vantage_TeS]

Snertz came up with a LP mod for the LCD. I am in the process of doing it to my gun, and I will be posting a review of it with step by step pictures in a couple weeks when its done (waiting for parts). As far as we can tell it works without any side effects, but LCDs are a little slower then IR3s so you might get a little shootdown. The best part of the mod is its not permanent and can be changed back to original settings at any time.

[RonnyMcDYO]

Yea im also working on making mine LP basically the same way Snertz did his, and no the regulator wont make it lp, you need to change the valve spring to allow the ram to work at lower pressures. The lowest you will get is around 60 psi.