A4 not firing ?? sensi prob or trigger??

[dailyluttrell]

Hey guys I`m tryn to figure this out for a friend , his A4 it`s seems , stops shooting , doesn`t shut off or anything like that , almost like the trigger pull didn`t register or something. settings are:
semi mode 1
dwell 16
lpr 55
tr 1
sensi on
halo b
Just tryn to get a little feed back before i get into it
any help would be great

[thog94]

Sounds like the trigger is set to short, back out the toe screw and see if that works.

[dailyluttrell]

Thought it was the trigger at first but it`s not consistant and seems to be fine w/out sensi on , although it still happens , just alot less. I adj. my trigger anyway and towards the end of the day , she seemed to work like before ..flawless
I think my halo may have smashed some paint into the breach ,i cleaned the sensi rod and plate off(some goo in there) so i`ll try her out again this weekend with my egg instead. Thanks

[JTp8ntballer12]

you should start looking into replacing your sensi too, the things you said happens right before the sensi totally breaks.

[dailyluttrell]

Well my speed(w/A4 up`s) was doing the same thing and after inspection , the sensor pad was broken. I ordered 1 and hope to have it by monday , as far as my A4 , the sensor looks fine , nothing discolored , or cracked. I know halo`s do`not produce enough force to break the sensor , but i`m going to stick with my evo 2 , just to be on the safe side ,, i`ll use the halo b on my ACE`d Dark lcd. I made some adjustments to the A4 trigger , i hpe that does it. The thing totally rips when i dry fire. Like 24 bps is the norm now.
Hey thanks

[spec_v]

make sure the SOL wire isnt plugged into the HOP location on the board. You title says WDP ceritfied service center, wasnt that the first thing they taught you in the class :)

[Frank_McCrank]

when i have my a4 on semi 1 it skips shots too. like i shoot as fast as i can and suddenly it stops a little and begins again.

[Devs]

I had a similar problem it would only shoot if I was pointing straight at the ground, or tilted the gun to the side at like a 45* angle. I compeltely took it apart, and found that there was a little paint on the metal piece that activates the optoswitch. cleaned it off and its been workin great ever since. try that. :)

Monkey

[dailyluttrell]

Semi mode 1 will not fire if no ball is detected and another pull must be made to fire. Semi 2 will delay the cycle but no 2nd pull is needed. And the delay is mili-sec. That was my problem , paint wasn`t feeding fast enough and the semi 1 mode rejected the pull. Semi 2 on and i`m back to shootin ropes.
Thanks for your input. (lol sol wire in hop socket lol thats funny)