My angel is asking for a PIN

[bunker17]

my angel is Asking for PIN number but i have not put any anyone know how to reset them withouth a cable. Please all info would be good

[tommygun]

did you adjust you're trigger recently? if so you could have set it so short that micro switch is pressed in and it can't move. it happend to me if it's not that you may need a new board.

[moocow870]

have you tried the code 0000. I think that is how someone got out of a situation like that.

[bunker17]

okay it happen like this i had my gun on in safe mode and i hold the trigger for a while then it went into the pin screen haven't been able to take it out of there any other help tried the all 000000 didn't work anyone know how to reset a board.

[Reverserewind]

try turning the gun off and then readjusting the trigger. It sounds like the trigger pull is to short so that when you turn the gun on the switch has already been tripped (ie the trigger it being pulled constantly). If you tried entering a pin you may have actually just created the pin for your gun. There shouldn't be a problem with the board but you will have to take it to your local WDP dealer to have the problem solved. If you have an LCD manual refer to pages 8 and 15.

[bunker17]

didn't work not any service center near i would have to shipped to get it to a center and it just came back form there

[Reverserewind]

It sounds like it may have been locked either by you accidently or by accidentally setting a pin number and locking it. You can also contact WDP directly and they can help you. (www.wdp.tv) the manual says you'll have to provide proof of purchase and ownership. You might find some better direction also from any of the master techs. Check out the shops in the banner at the top of the page and contact the closest one. They're all super helpful.

Oh here's the manual (http://www.wdp.tv/manuals/index.htm?lcd_manual/) for the LCD online if you weren't able to read up on the pin info.