KEN CRANE
04-19-2004, 01:44 PM
we recomend a low pressure air system 450 psi output
new gun set up
non eye mode 15 bps (this way if you shut your eyeq system off the rof will not exceed the hoppers ability to keep up.) this should eliminate paint breakage if the eyes foul or stop working
dwell 12
lpr 55
imput to gun 190 or so
tr 12 or so (remember low is now a lower bounce factor and a higher number is a higher bounce factor,unlike the a4)
after you have broken the gun in you can begin to lower the dwell as well as the mini reg pressure.dont go below 8 on the dwell and 40 on the lpr as performance begins to suffer.
we are now recomending a halo or egg 2 with z board.
with a halo the hopper speed on the gun should be set to sfast.with the egg2 with z board it should be on fast.keep in mind the slower the hopper turns the slower your rate of fire will be.always check your hopper for slow or intermittent rof fire issues by borrowing a known good loader from another player.
if you buy a realoader b make sure you set the speed to the fastest setting as it is not adjusted from the factory.
if you have a high pressure tank you can modify the mini reg to lower the spring stack pressure so you may adjust the gun below 300 fps.
1) remove all pressure to the gun.
2) remove the mini reg from the gun by unscrewing it counter clockwise
3) look into the top of the mini reg and locate the circle 'c clip'
4) with a circlip pliers remove the circlip
5)carefuly turn the mini reg over and tap it on a padded surface
6) you will note that there are cuped washers stacked on top of each other they look like this: ((()))((())) (not in this order)
7)remove 1 of the cuped washers (springs) from the mini reg stack
8) reassemble in reverse order and re chrony
new gun set up
non eye mode 15 bps (this way if you shut your eyeq system off the rof will not exceed the hoppers ability to keep up.) this should eliminate paint breakage if the eyes foul or stop working
dwell 12
lpr 55
imput to gun 190 or so
tr 12 or so (remember low is now a lower bounce factor and a higher number is a higher bounce factor,unlike the a4)
after you have broken the gun in you can begin to lower the dwell as well as the mini reg pressure.dont go below 8 on the dwell and 40 on the lpr as performance begins to suffer.
we are now recomending a halo or egg 2 with z board.
with a halo the hopper speed on the gun should be set to sfast.with the egg2 with z board it should be on fast.keep in mind the slower the hopper turns the slower your rate of fire will be.always check your hopper for slow or intermittent rof fire issues by borrowing a known good loader from another player.
if you buy a realoader b make sure you set the speed to the fastest setting as it is not adjusted from the factory.
if you have a high pressure tank you can modify the mini reg to lower the spring stack pressure so you may adjust the gun below 300 fps.
1) remove all pressure to the gun.
2) remove the mini reg from the gun by unscrewing it counter clockwise
3) look into the top of the mini reg and locate the circle 'c clip'
4) with a circlip pliers remove the circlip
5)carefuly turn the mini reg over and tap it on a padded surface
6) you will note that there are cuped washers stacked on top of each other they look like this: ((()))((())) (not in this order)
7)remove 1 of the cuped washers (springs) from the mini reg stack
8) reassemble in reverse order and re chrony