How do you remove led solenoid and breech block?

[eyesonlybob]

i am tearing my 97 led angel down to get annoed. everything is out except the solenoid and breech block. am i right to assume that you screw the solenoid out? can i use some snap ring pliers?

also, how does the rod holding the breech block on come off?

i can get pics if needed. thanks for your help.

[Dj Pyro]

i hear if you blow hard enouf it should pop right out....j/k (dont try this at home) lol... no problem for you huh buddy

[eyesonlybob]

dont crap on my thread just because you know me.

[Emmit]

I'd say check the manual,

it's been too long since I've seen the inside of an LED...

[eyesonlybob]

the manual didnt have anything about the removal. it merely says "remove the solonoid" heh.

but i did find out how. there is a grub screw at the top of the body. take it out then put a dowel rod through the body and breech and tap with a hammer and it came right out.

i was told the breech rods have 1.5mm threads in them. i went to sears but the smallest they have is 3mm. we'll see how the search goes tomorrow.