End Cap question

[illy2k]

I took off both end caps, to check out the LPR and the exhaust valve stem. I wanted to know when you stop tightening the end cap when you put it back on. Since it has an o-ring it shouldn't be tightened until it is snug right? How do you know when it is tightened enough. Oh yeah, on a side note, I didn't realize that end cap was gonna shoot off the valve stem like that. There was some grease on the o-ring holding it back, then all of a sudden the end cap shot right off. Lucky thing I found it. :dil:

[thog94]

Tighten the end cap until it's flush with the body of the gun.

[PlazmaSpeed]

I took off both end caps, to check out the LPR and the exhaust valve stem. I wanted to know when you stop tightening the end cap when you put it back on. Since it has an o-ring it shouldn't be tightened until it is snug right? How do you know when it is tightened enough. Oh yeah, on a side note, I didn't realize that end cap was gonna shoot off the valve stem like that. There was some grease on the o-ring holding it back, then all of a sudden the end cap shot right off. Lucky thing I found it. :dil:


lol same thing happened to me with the end cap and the spring load tension.

[MoogLe]

Tighten the end cap until it's flush with the body of the gun.
yep, you dont need to tighten it