PDA

View Full Version : LED colour when chargeing


Adam_Angel_Guy
03-28-2004, 12:21 PM
what colour does the LED go when chargeing the gun? thanks.

Emmit
03-28-2004, 12:43 PM
Operating Instructions: Charging

(See Figure 1)

Before initial use of the Angel™, it is necessary to give the power pack a full charging cycle of 14 hours prior to use as this will ensure the longevity of the power pack. Subsequent charges will be in the region of 3 hours for full charge.

Stage 1

Insert cigar lighter into a 13.8v negative earth socket as found in most motor vehicles (red light on charger will illuminate).

Stage 2

Ensure isolator switch on the Angel™ is in the forward position towards the barrel. (No charging can occur until this switch is in the forward position).

Stage 3

Insert remote plug from charger into the socket on the rear of the Angel™ (See Figure 2).

Warning

Care must be shown with the charger to ensure the remote plug is not pulled or twisted by the lead.
Shortening this lead can result in damage to your markers electronics.

Stage 4

The LED on the charger will indicate the status of the charging cycle on the Angel™.


1. NO LED: power at cigar socket not present! Switch ignition on
2. DIM RED LED: isolator switch on Angel™ is on ! Switch isolator off
3. BRIGHT RED LED FLASHING: indicates battery conditioning from totally discharged battery
4. BRIGHT RED LED: indicates rapid charging occurring
5. GREEN LED: indicates trickle charging occurring, battery achieved 30% capacity


NOTE: The Angel™ may be left charging for prolonged periods without damage occurring to the battery pack.


straight from the manual found here http://www.angel-owners.com/manuals.php

Adam_Angel_Guy
03-28-2004, 12:48 PM
thanks u i thought it had to be in the off position to charge

Emmit
03-28-2004, 01:04 PM
it does...it even says so right in that blurb I copied...the forward position is off...read the "Stage 4" portion again.