Egg falls off

[MadSpeed]

Well, the first time played with the egg, the damn thing fell off like 5 times, then i tightened the neck, and... it fell off again, does that mean i need to sand it down a tad?

Also, It does not work so well with the JT speed pods, Warped was liek this revvy is better... and theres no neck for it... ARG!

So in the end do i just need a new harness and pods too?


Thx.

[mamba_juice]

sanding it would help, but i would recommend that you buy a check-it clamping rise. it has never given me a problem.

[drkanglr]

Speed pods work w/ the Egg, you just can't use the speed collar. I wouldn't buy new stuff. Anyway, you can fit a few extra balls in there w/ the shape of the lid. I second that emotion on the clamping rise - I don't have any problems w/ my Egg to marker fit w/ mine.

[MadSpeed]

I think Wared gave me sa clamping rise, the A4 one, has red inserts and stuff... but is the check it one better?

Thx

[mamba_juice]

i actually think it is, my experience with twist locks is a long and horrible tale

[Hep]

Use the smaller o-rings that came with your gun and you will be fine as far as using a Egg and it should bottom out then. I used them and had zero probs. Although I did cut down the feedneck on the Evo since it had more than enough room to cut down heigth wise. But like said before I switched to a Check-it clamping low rise and I likes.
Hep

[JEREMY]

ya the a4 clamping feed was a bad design the orings get all out of aline and plus it doesnt clamp down very tight at all. go with the checkit for sure i love mine!

[thog94]

If it's loose and falling out why sand it and make it smaller? Never had a problem with my twist lock feedneck. As Hep said, you need to use the extra o-rings that are marked (mine were marked with a yellow dot) so the egg fits properly. If it's slightly tight, just put a little Love Juice on the rings and it should slide right in.

[mamba_juice]

but you gotta admit that a lo-rise does look better on an angel

[thog94]

but you gotta admit that a lo-rise does look better on an angel

I'm not saying that a low rise looks better or worse. I'm just saying that the twist lock works for me so there's no need for me to change it.

[mamba_juice]

yeah...you got a point, kinda like volumizers on an ir3

[thog94]

Yeah whatever you say...

[MadSpeed]

Thog, it wasnt an issue of being to small as to it being too big, I think, it would go, just not as much as I would have liked it too! But i will check ou the check it stuff, i already got a drop from them... so more sounds fine.