chopping led help!

[DRAGONPHX3]

I have an led & it usualy works great. i recently took it in for a trigger job & when i got it back it chews up almost every shot

[walbuls]

I'ed take it back and make them fix the prob they made.

[Crazy4Paintball1]

What kind of loader do you use? Does it chop during fast fireing or even when you are just shooting normal? I know when i got my triggerjob done i was no longer able to use a revvy so i upgraded to a HALO B and i have been fine. But if it is shooting normal that it chops i would agree to take it back and have them fix it.

[DRAGONPHX3]

I AM USING A 12V REV & IT CHOPPED ON NORMAL SEMI IT REALLY SUCKS. I HAD GOOD PAINT TOO. WHAT KINDS OF PAINT WORK BEST FOR YOU?

[limitdliability]

could you tell if the bolt was actually chopping the paint or was the barrel chopping the paint? sometimes you'll get a bad batch of paint and it ill chop like mad. but if its your bolt then you know it is either your tuning or your feeder. does it chop when you fire slow..say around 2-5bps, or only when you hammer on the trigger? if its nly when you fire fast, i would tell you to invest in a Halo B or an Evo2. but if it happens during the low firing too, then you may need to get your gun tuned again. just my 2 cents though..godd luck

[DRAGONPHX3]

THANKS FOR YOUR IN PUT BUT IT DOES CHOP WHEN I FIRE VERY SLOW I USED TWO KINDS OF MY FAV PAINT. WHAT HAPPENS IS THAT THEW BALLS GET CHOPPED IN HALF BY MY BOLT & THE ANGEL GETS JAMED. THEN I HAVE USE SOMETHING TO COCK IT BACK. THANKS

[mncastro]

Before you take it back, make sure the ball detent is still good.

[Crazy4Paintball1]

When they adjusted your trigger, they might have shortened it too much, which means the trigger is always set back and not therefore it will set the bolt off pretty earlier. There was a problem similar to this on AO forums in the angel section, except his was as soon as he turned his gun on it would start shooting. I would def get a different loader anyway...like i said before i got a triggerjob my 12 volt could not keep up. Yeah make sure all your parts are working ok, i dont know if it is your ball dentent unless you are double feeding. I use alot of RPS paint. PMI Premium, Marbs, and the newer EVIL paint. All work great.

[DRAGONPHX3]

my ball dent looks & feels ok. I too use rps premium alot (it likes that stuff). i am planning to use a buddy ricochet & see how that goes. thanks but still chopps. If i don't get it fixed i might sell my rig & get a 02 intimidator red polished. sweet!