Breech block wont close

[thedeem0n]

i pulled my breech knob back a little while ago, and when i went to hinge it back into place, it wouldn't go all the way back in.when i take the bolt out, it will shut all the way fine, but with the bolt in, the silver pin on the bolt is getting stuck on what i belive is a part of the LPR, but im not sure, this happened once before, but it didn't last too long before it went back in to place, but this time its giving me a little more of a problem, and help is appreciated, and i would like to avoid taking the gun apart at all costs

[WarpedKid02]

Your breech is off a little bit. You need to adjust it.

[thedeem0n]

i got it to close with the bolt in, but im still afraid to fire it, i pulled the brass piston thing forward a little, and now the pin is resting in the groove on the brass piston, before i fire it, is that okay, or is the bolt pin supposed to be in front of the brass piston?

[killerbombo]

Click on "Manuals" at the top of the web AOG web page, click on Angel (LED), and look up Ram adjustment. You need to adjust the ram (the hammer, "brass part", is attached to front of the ram", this will allow the pin in the bottom of your bolt to sit in the groove on the hammer correctly. This should correct any bind between the bolt pin and hammer groove, or problems with the hammer not being centered in the breach correctly (both are related and will cause your breach to bind). Take some time and read the manual, lots of good information....