Led battery replacement

[Sapper]

I'am trying to change the stock battery same for same. Can anyone give me some advice on doing this myself. I have the gun open and this thing is a mess! Or would it just be better to send it off to get this done.
Thanks
Brett

[Sapper]

Thanks...but I dont have a manual and I dont have the battery out yet. It looks like the wires are all tangled together and I cant push the battery either way without putting pressure on the smaller wires that go down into the grip frame. I pulled the grip frame off but that doesnt give me much room either. I think I will send it off for installation and a tune up.
Thanks for the advice.
Brett

[Emmit]

while I've never bothered to replace the battery on any of my Angels, I'm going to bet that you'll probably have to unplug the wiring harness from the board. That will allow some more room to move around, you'll probably have to unscrew the switch from the grip frame as well. Just make some notes as you're going along so that you don't forget where you plug something in.

[Sapper]

Thanks guys! I unpluged the harness, trigger switch, and the on/off switch and it gave me enough play to get the battery connection out the back of the gun. It only took me about 20 minutes from start to finish.
Thanks
Brett