Setting the LPR using a 800 psi tank

[2k2_Angel_LCD]

Setting the LPR using a 800 psi tank -

Can you set the lpr using a (non-adjustable, preset) 800 psi tank (68/45)? Any guidelines on how?

Please don't tell me I just wasted $55 on a angel toolkit that won't do me any good (I don't have access to a 500psi tank (like angelguy.com recommends) .

[WarpedKid02]

You will need the Angel Tool-Kit for checking your LPR Pressure.

[2k2_Angel_LCD]

Thanks Fearing, your always a great help.

So, in other words, your LPR should be set to the tank you are using, at a standard FPS (285-90) or whatever. That makes sense. I'll figure it out.

I wonder then, say you send it to the angelguy.com and he sets it with a 500 psi tank, would your LPR likely be too high if you put a 800 psi on?

Thanks again for your help.

Warped - I know you need the toolkit (that's why I mentioned I had one on the way).

[2k2_Angel_LCD]

Thanks J!

I just plugged in my tank and tested it, and it was right at about 85 PSI.

I also tuned my angel for the first time, and so far, it seems like I did a pretty awesome job (took it out back and it was shooting laser beams! better than before the tune-up). I think the ram wasn't adjusted properly.

One thing: I didn't have any low strength loc-tite for the snap ring, am I going to have issues? Or, will it likely stay put (at least for awhile)?

Thanks again!!