intellifeed install on a Speed

[Morphius]

I want to put my warp on my speed. Where on my speed do I wire in the cable that plugs into the warpfeed.

Any and all help is greatly appreciated!!

Thanx,
---Frank---

[Vantage_TeS]

Intellifeed is for Viewloader Revolutions. Not to mention that the speeds cant power an Intellifeed hopper because they now run on a lower volatage than older angels such as the IR3 or LCD (speeds use 4.8v).

Never heard of anyone running a warpfeed off of intellifeed, but I know on the LCD that you have to buy an intellifeed rail.

[QuiQafooQey]

http://www.angel-owners.com/showthread.php?t=10255

The Angel was not designed with a warpfeed in mind, some people have said they've spliced into the intellifeed wires, but since the Speed doesn't have the intellifeed either you're SOL.

at least thats what the search brought up.

[Woogie12]

Is the plug that says hopper in the board there for no reason then?

[QuiQafooQey]

Intellifeed is for Viewloader Revolutions.

its there for your revvy ;)

[Vantage_TeS]

email from Fazer


The speed will not work the revy it is only 4.8 volts

All the best,
Frazer Colley,
frazer@wdp-paintball.com

This was the reply from my original email which asked if a speed would run a 12v Viewloader Revvy with an X board.

[QuiQafooQey]

i've seen pics of it hooked up, if my memory serves me right the owner had to mod it a wee bit.... i'll see if i can find the thread

EDIT:
---Right well i cant find the thread/pic, so just ignore me.
---Morphius - l3abba got a warp hooked up to his angel, you can find the pic at http://www.angel-owners.com/showthread.php?t=7023&page=7&pp=15
just give him a PM http://www.angel-owners.com/member.php?u=4802

[QuiQafooQey]

this is what i was thinking of: http://www.angel-owners.com/showthread.php?t=488

[jdub23]

speeds dont have a place to put the wiring in, in that thread he uses an older version angel

[Krystalmesh]

our friends at theangelguy.com have successfully intelli'd the egg. heres the link
http://www.theangelguy.com/forums/showthread.php?s=&threadid=63

[Morphius]

Hey guyz, thanx for all the input...

The only thing is... I am wiring in the cable that activates a WARP FEED, NOT a revvy,egg or any of those other slow feeders. :pointandl

It looks as if there is a "Hopper" plug in on the board. I am going to find the correct end and make a cable that will just plug into that. Hopefully it will work.

[Krystalmesh]

I wish ya the best of luck pal. If you get a working version, I'd say make a thread on a 'How to' with some pics, Im sure there are others who are interested in Warp Feed/Intelli-ing there angels. Good Luck!
Josh