macdev conquest air system: output pressure?

[mika]

help!!!!! what is the best setting for output pressure out from tank to gun. i like playing around middle to front.:puzzled:

[pollacjw]

Set output to 550-650 if using the min-reg as your inline.

[CoBrAiR3]

shoot son.... cobra had my output preasure on my conquest set at 750 psi

[A.Sanidad-AOG]

Mine is set at 650

[Mrp8ntball]

NO, its 600...

[Mrp8ntball]

with a quest, in the manual it says to run an angel at 500-550 because it has very high flow rate or something, i run mine at 575ish and it works good. Ill try lower settings when i get around to it, for now its rockin and i dont want to jinx it.

[HeadbuttKing]

But at that high pressure it is impossible to push the lever dwn....

I just did what Rock did and hollowed out my Minireg and run it at 400 - 450

[HeadbuttKing]

Why is that bad?

Worked alright for me Wed....

My velocity problems werernt too bad....+-4 and once t jumped 10 but thats better then it was with my Reg on...

It is impossible to get the pressure that high on a MacDev!

[A.Sanidad-AOG]

hmmm... my guage must be wrong when it reads 650psi...

[Mrp8ntball]

ive noticed that my system can go over 600 as well, it is somewhat the inaccuracy of the gauge, but it does actualyl go over 600. i think the problem with going over 600 is it puts too much pressure on the seals. the system is meant to stay at or under 600, regardless of what it may actually go to.

[IanR]

Originally posted by J.Fearing-AOG
MacDev does not recommend you single regulate their system. Numerous people have emailed them asking the question of single regulating their systems, every reply has been "not recommended."

I believe that Air America's reg wasn't designed to be single reg or reccomended as one but that seems to work great on a lot of people's markers.