Switch doesn't reset on activation point.

[anonymousducks]

My microswitch doesn't reset on the same point it fires on my LCD, i'd have to release it a bit more for the microswitch to be able to fire again resulting in the need for a bit longer trigger pull. Is this normal? or is something wrong with the switch?

[Emmit]

sounds about right

[crashdan]

there are 2 screws, mess around with it to find a good spot for yourself, if u move 1 a lil forward move the other back a lil or somehting

[anonymousducks]

Yeah i've tried a lot of trigger lengths. Ended up with the same result, I would need about 3mm return to reset the microswitch instead of it getting reset a bit after the activation point.

[morant]

that's normal....it's a switch, it does actually have to move a little to opperate.

remember shorter is not necessarily always better.

[Pottorf]

it is to me

[anonymousducks]

Yeah, my speed trigger is set very short and thats how I like it. I know the LCD can't get as short as it, but my concern is that I have an unusually long pull for an LCD compared to other LCDs.

I figured that the microswitch is probably worn or something so i'll either solder a new one on or have a board swap.