vegetable
12-02-2003, 05:45 PM
Hi
I just have a few questions about low pressure on an Angel:
I was wondering what the different ways to make my speed for LP were. Is there anything I can do with the valve? I know about the lpr, and lowering the ip pressure on my angel air, increasing the dwell etc. But is there anything you can do out of the manual?And is there a way to lower the pressure pushing your ram?
Also, will low pressure not related to the dwell still increase kick, gas usage, and noise like raising the dwell does? Or is that just disadvantages of a high dwell cause the valve stays open for longer?
And 1 more thing, is high pressure bad? Like with LP, I don't understand how it effects grouping. I run my dwell at 9, with an input pressure of around 200 psi from my Ange AIR. Is this bad for grouping? If so how does LP really effect grouping, I asked a few local WDP cert. techs and they said it doesn't, it is just a myth or used as a marketing scheme.
I just have a few questions about low pressure on an Angel:
I was wondering what the different ways to make my speed for LP were. Is there anything I can do with the valve? I know about the lpr, and lowering the ip pressure on my angel air, increasing the dwell etc. But is there anything you can do out of the manual?And is there a way to lower the pressure pushing your ram?
Also, will low pressure not related to the dwell still increase kick, gas usage, and noise like raising the dwell does? Or is that just disadvantages of a high dwell cause the valve stays open for longer?
And 1 more thing, is high pressure bad? Like with LP, I don't understand how it effects grouping. I run my dwell at 9, with an input pressure of around 200 psi from my Ange AIR. Is this bad for grouping? If so how does LP really effect grouping, I asked a few local WDP cert. techs and they said it doesn't, it is just a myth or used as a marketing scheme.