Choppin paint!!<<.....

[KillaPaiNt]

Well i have a speed,wit a check it low rise and 800 preset tank,and a new dezign volumizer on the exxzle valve...i mean i will shoot 4 balls a second and it will blow them apart to nothin....i was usin a egg,i tryed everything so far,new ball detents,fresh paint,everything.....would the problem be the mini reg can't handle the pressure cause an angel tech checked the pressure and,when the velocity screw was all the way in it was runnin 300 and when all the way out 700...what the cause it to blow paint to nothin>???.....cause he tryed it wit a low pressure tank and no paint blowin up...also,it much worse wit my z code halo....??..lpr is at 80psi....

[Sp00n]

An egg should of been perfect and my halo b works fine on my speed but on other peoples on this forum it doesnt sometimes, But with a high preset tank, Take out a few shims and start from there. :puzzled:

[RedlineRex]

i'll just throw this out there... possibly ball/barrel match or maybe even decrease your dwell a little bit. maybe a shorter barrel will decrease your velocity a bit (which doesnt really fix your problem but may allow you to pass chrono). i'm sure you already tried the ram adjustment, but i didnt see it on your list.

[DogSniffMe]

ram adjustment fo sho.

[GRIFTER]

Sounds like ram adjustment to me. You may be getting roll back. An A-4 bolt helps with that.

[KEN CRANE]

checl your lpr pressure.should be around 70 set your dwell should around 11-12.

[Luzrd]

i agree with what everyone has said so far, i had similar problem
i thought my ram was out of adjustment, it turns out that i used the wrong barrel bore by mistake (izle)

[ezrunner]

the output of your minireg is definately too high. KEN CRANE: Minireg Spring stack?

I'd either try to change the minireg spring stack configuration to handle the high input air, or change inline regs to an aka sidewinder, or use a lower pressure tank.

The best situation would be getting a Low Pressure Crossfire tank, they are making sweet magic on the speeds.

-rob

[ezrunner]

oh: all the way in and it should be 0 psi coming from the minireg, all the way out should be whatever your tank puts out. Your minireg could need a reg seat and a servicing, or your tank may be putting out more than 800 psi.

-rob take 2

[KillaPaiNt]

ok,well i just got a low pressure tank..a xtream ajustable nitro duck...hopefully this should solve the problem..also what is the best input pressure i should put my nitro duck at?...

[Luzrd]

i run my x-stream at 400,which is what my manual says is the ideal pressure

[krispy]

me too