Speed+AIR+HALO=?

[XrXiXtX]

Hey guys. I was wondering what settings i should use with my speed running a Halo b (z) AIR set at 400 psi, and medium volumizer. THANKS
Right now im on mode 2 dwel-12 and i havent touched the lpr since i got it.

[evilempire]

Angel recommends you run your gun at 14 dwell, but other than that, nice set-up.

[Luzrd]

alot of threads about settings look around, i like ezrunner's thread myself

[ezrunner]

Thanks Luzrd :)

If your speed was factory set the lpr is at 80 - 82 psi.

The dwell should work fine in the 11 ms range, maybe even 10 ms but if you get drop off bump back up. This will give you better efficiency and I haven't had any problems about it being hard on paint at all.

The AIR I'd run at about 500psi into the minireg and start the minireg at 0 psi and adjust up till the velocity I wanted. That should land you around 165 - 180 psi valve pressure.

The HALO good luck with. I kept breaking paint with a HALO but I went to a Y-board Egg and the gun cruises paint as fast as I can roll on it. I run a TAG volumizer on the valve side and non on the LPR side.

Neither Bob nor Mr. Crane have told me any reason to run a volumizer on the LPR side and I trust the word from those two. They are the best angel techs I know (but I don't know any of the other site sponsors).

-rob

[ezrunner]

BTW here is the thread on the settings.

The 14ms dwell time is perfect for the LCD Angels, the speeds run lower because of the ram and valve redesign.

http://www.angel-owners.com/forums/showthread.php?s=&threadid=15165

[kasanova]

Yall do know that the new halo was specifically designed for the angel, dont you.... this is the new one with the z-code and the zip drive...