Problem with LCD screen...

[NASA racer]

Also had a problem last night where I'd click my gun on and wouldn't see anything on the screen. Was VERY intermittant. If I let the gun sit it would usually come back normally. Shows no fault and the temperature was never less than 62 degrees.

Just a bad board or is there something else I can look at?

[IanR]

Is the connection between the screen and board good. That is most likely the problem. Was the gun charged ?

[NASA racer]

Thanks, I didn't realize the LCD screen was held on with a connector with four pins so I spread the pins a bit to make a better connection and I believe that did the trick!