trigger stuff

[sumgui0013]

i have a stock trigger how can I get rid of my side to side play and what can I do to get a wider trigger, not looking to buy another either

[capnut]

well i did get rid of the side play.....what you have to do is take out the pin and go to the hardware store and find a small washer...buy a few and then get sand paper....like 200 or 400 gt.........now, what you have to do is buff the trigger to get the imperfection....other words get it like a mirror on the sides..........now take the washer that you got and start sanding......this will take some time and do both sides.......what you do now is put the pin in half way then put the washer in the other side....what you are looking for is the washer to go in with least resistance if the trigger is hard then take it out and sand it down more.....keep doing this ontil you get what you are looking for it will take some time but it will happen....noe put some lube there and have some fun........my side to side play in my guns are about .002 and my guns are shooting around 18bps to 19bps.....O....plus my trigger work that i did to......if you need some help e-mail or i can put up some picture for you and everone else????

[capnut]

yes, you can do it that wat too what you going need is a 4/32nc screw and a drill for that ....from there you must take off the grip and look at your look at your trigger...where you put it , is about 1/4 back from the hole that is there.........that the hole form the grip..

[dr.strangelove]

I put a little bit of electrical tape on either side of my trigger. It all but eliminated the side to side play, I didn't have to drill a hole in the grip frame, or waste my time sanding my trigger and washers and the trigger pull is wicked.

[Arch-Angel]

Does anyone have a pic of the third set screw.