Factory Setting LPR

[DogSniffMe]

what does the speed's lpr come at direct from the factory? i hope its 82, cuz i don't have an angel tool kit, but i wanna air it up this weekend. i just hope the lpr isn't too high or too low to screw me up, i'm a little paranoid. thanks.

i'll be running a nitro duck x-stream into the mini reg at about 450-500 psi. with no volumizers as of right now.

[ezrunner]

mine was at 82, once i got 4 cases through it I dropped it to 75 and I run a tag volumizer on it.

-rob

[DogSniffMe]

y do u drop it to 75?

[acoenfam1]

With the volumizer on there's no need to hit the valve as hard due to the lower pressure on the other side.

[F5monkey]

plus the bolt will hit the ball softer

[ezrunner]

basically what they said :)

I'm working with the guys at TAG on a way to drop it to like 50 psi so stay tuned.

This would take out nearly all movement (recoil) shot to shot and your bolt would stop on a ball.

-rob

[autokokcer]

Oooooo........

keep us informed.

[smasher41]

mine used to run at 65-70 with no volumizer shooting 296's all day, worked fine, at the tech class i raised it back to 79, havent had a chance to change it back yet.

when setting the lpr the inline pressure was higher so the lpr was around 79-82.

the pressure going into the gun matters when setting pressures.

[DogSniffMe]

so will i be ok airing it up this weekend with 450-500 psi going into the mini reg? remember, no angel tool kit, so i have NO IDEA what my lpr is at.

[acoenfam1]

You should be fine. Just don't be surprised if you have some minor performance problems i.e. drop off on long strings etc...