PDA

View Full Version : ANGEL opperating pressure

bluepeter7
10-26-2002, 03:04 PM
what is the operating pressure of an angel? there is quite a debate about this around where i live
5150
10-26-2002, 04:54 PM
It could be from 250 too 800.
djmjohan
10-26-2002, 05:18 PM
The operating pressure is somewhere around 380 psi.

You can determine this by single-regging your Angel and putting an in-line guage on it. Or if you have a very accurate guage on an adjustable tank, just look at what the output pressure is.

380 psi on my IR3 gets about 280 fps over the chrono. Adjust to taste.
perpetuul
10-26-2002, 05:47 PM
the tech by my house said 400 psi
AdrenalinMan
10-26-2002, 05:51 PM
i run my AIR at 350psi and get 280.(i have a gutted reg)
CrazyIrving
10-26-2002, 05:56 PM
The manuel say 600psi, so thats what i put mine at.

I too would like to know which is the suitable setting, I'm using a maxflow.

More info is never to much

One more thing you can adjust the PSI on the Maxflow to bring down the FPS or do we use the screw on the mini reg I'm just getting the hang of these new information.

Thanks

Crazy Irving
perpetuul
10-26-2002, 06:03 PM
umm, this thread is talking about STRAIGHT into the gun, not from tank, 600 psi is fine from out of tank, and then your reg should be set about 400 psi for about 300 fps. i was looking at some of the pros and they like to set their tanks at 650 psi...so whatever works on your angel i guess

as for FPS, it is better, if you are using the minireg, to adjust from the mini reg, not from the tank. At least in my expiriences
karrkrash01
10-26-2002, 07:04 PM
it depends i have seen iput pressures from 325 to 395 so somewhere in that ballpark.