Inconsistent (part 2) ???

[havepaintwillshoot]

I am a new Angel owner......

I have a 2k2 Dark LCD and I am having velocity problems. I am getting ranges in velocity of anywhere from 20 to 50 fps. I went through some of these threads last night and saw that the majority of the advice for this situation was to clean the minireg. So I removed the minireg - pulled out the c-clip - removed the spring pack, piston, and ball bearing. I cleaned them all (there were not dirty) and replaced with lubrication. My fps range got better (was about a 60 to 80 fps variation) but it is just not consistent. Any ideas?

My dwell is at 14.

[MoogLe]

did you check your lpr?

[havepaintwillshoot]

Nope,

I do not have a gauge to do it. Would it help to just pull the parts out to clean and lube them?

[havepaintwillshoot]

Another thing - where is the breech o-ring?

[MoogLe]

the breech oring should be right around that little hole under tha part of your breech thatr swings open, and well it MIGHT help if you clean the lpr and lube it, but if the pressure is too low/high it will still be inconsistent, borrow one if one of your friends have one or if not you're just gonna have to buy one

[havepaintwillshoot]

AHHHHHHH - I don't have a breech oring. I have just had the gun a couple of weeks. Where can I get one quick and do you think that may be the problem

[MoogLe]

well any of the sponsors should have one, and i doubt it would cause such erratic inconsistency only a slight loss of efficiency but you never know