Sensi and Trigger Problems

[Rowdy6789]

Hi I just got a Speed. The trigger is really stiff and it doesnt come back fast enough, and it squeks when being pulled. How can I help this? Also I think I will be runing a Xboard Revvy on it, what sensi setting should i put it on? And how do I change the sensi?

THanks


Rowdy

[deadeye_85]

read your manual dude in regards to the Sensi modes and how to change them. Mode 1 and 2 are the fastest. 2 has a slight chance of chopping, while one doesn't so I lean to mode 1, but many people here use Mode 2 with no dramas.

[acoenfam1]

Yea check the book it does a good job of explaining the different Sensi modes. As for the trigger I spent about 30 minutes working on mine last night and got it right where I want it it's real easy. As for the squeaking put a LITTLE, say again LITTLE Love Juice Grease on the Opto switch and that should help.

[Rowdy6789]

dont have love juice can i use gold cup? also, theres two screws to set the trigger right? or are tehre three?

[delinquent54]

well, there are two screws that adjust the overtravel and return, then there is a third called the toe adjustment screw, the toe adjusts the length of the pull so to speak, meaning the further back the toe, the less you have to pull to activate the leaf spring, and vice versa. just take a good long look inside the frame and how the trigger itself is setup, and u will understand what i mean (read the manual also). also if u bought the gun brand new it should have came with a bottle of love juice...

[p8ntballdude]

un screw the trigger pin screw just a bit and see if it helps. i had mine tighten'd too much and it would be heavy, then get stuck back. just try that before u go oiling everything up. if that doesn't work lightly oil the trigger pin and the opto switch.

[acoenfam1]

NOT THE OIL!!! Use the grease or maybe some DOW 33! Put it where the TOE adjustment meets the leaf switch.

[Rowdy6789]

what is dow 33 normally used for and where can i get it?