Stock Shims

[perpetuul]

In the angel manual it says that each shim is aproxx 0.2 bar, but when i put mine it, it raises my lpr 1 whole bar, is anyone else having this problem? could it just be a thicker/thinner set of shims or something? or bad shims? also, i can't get 300 fps w/ my LPR at about 85-90 psi, but when i add a shim it goes up to about 100-105psi and then i can get 300 fps no problem, BUT i chop like a motha'! i've tried w/ three diff types of paint, so it's not the paint, and it's about every 12-13 balls i chop (not out shooting hopper, it's an evo) any help is appreciated, thanks

oh yeah, using cobra bolt (also tried stock, same problem)

[karrkrash01]

the ir3 lpr should be set around a 100 to get proper velocity

[karrkrash01]

is ur ball detent only hand tightened if not this will lead to chopping problems. happened on my lcd

[perpetuul]

yeah, my ball detent is fine, i checked it a few times while playing, btw, howcome no one else chops at 100 psi? :cry:

[karrkrash01]

try raising your dwell to 15 or 16.
and make sure your paint is good and fairly new.
and are you chopping or breaking balls in your barrel??? If your chopping how fast can you shoot your ir3 and what kinda loader are you using. you may be outshooting you hopper. do you have your cops on/off???

[karrkrash01]

what kinda barrel you got on it. i know if your paint to bore match is really really tight it will bust ball bout every ten shots