Upgrading MEM and COPS????

[jhu2005]

Upgrading Mem and cops. I have an IR3 with mem3 and cops1, I want to upgrade it to 6 and 2 respectively. What ways can I do this? and how much will it cost approximately

[lovejuicer77]

HEY PAL.....if u do a search....you will find all the answers you need....there is about a ton of these threads on where and how to upgrade mem and cops

[warpedx]

Look at the wdpservice.com page, all the answeres are there.

[jhu2005]

Ok, so if I want to go from mem3->mem6 and cops1->cops2 It will cost about $185 or is there some easier way?

[Emmit]

if you want to go to the opto trigger and Cops 2, then yes it will cost $150.......no easier way, that's it.

[jhu2005]

IS it worth the upgrade? How good of a performance boost will i get?

[Ir3Flyer19]

if you dont chop without cops then there is no need for cops just set your mrof equal with your loader maximum feed rate.

[C]-[iLDe]

imo COPS2 works a lot better than COPS1 and the opto trigger allows for a nicer, click-free trigger pull. I think its a worthwhile upgrade....assuming youre keeping your iR3 in the first place.