PDA

View Full Version : Buttons offset/ charger offset

SPEEDFREAK1217
07-27-2003, 07:24 PM
Hey guys,
I just got my speed yesterday, so of course I wanted to charge it so that I could shoot it. But the location of the pin for the charge is offset to far to the left so I have to remove my skins and take to borad out of the grip from to charge it. I also notices that the location of the three button on that back of the grip don't line up very well to the buttons of the borad. They barely make contact, thus some times when I switch modes I have to hit the button two or three times. I going to call wdp tomorrow and talk to them about this. I was wondering has anyone else had a problem like this, and if so what did you do?
kylelynch
07-27-2003, 07:32 PM
mine was perfect.
BONES
07-27-2003, 08:05 PM
When you switch between modes you do have to hit the button a couple of times. That is normal.

You should be able to posision your board in there right too so you wont have that problem. Make sure you fully charge it 2 times before palying with it. And how did you charge your gun with your board out of it? You have to have the battery coard hooked into the board....
SkeL
07-27-2003, 08:37 PM
All he did was remove the screws that hold the board in, not disconnect everything. There's nothing you can really do except seeing if you can put the board in a different spot somehow. Other than that, all WDP is going to do at MOST, is send you a new board/frame.
MoogLe
07-27-2003, 09:16 PM
maybe a factory fault
SPEEDFREAK1217
07-28-2003, 12:13 AM
Well there seems to be some confusion so here are some pics of what I am talking about.
SPEEDFREAK1217
07-28-2003, 12:14 AM
.
MoogLe
07-28-2003, 12:18 AM
could you maybe make a more detailed picture? i really cant see anything wrong in those pictures, maybe a close up of the problem
gabs
07-28-2003, 10:48 AM
You might have a charger with a wrong plug.. A couple of my frieds got chargers that didn't fit inside the hole of the frame..

The plastic/rubber thingie on the plug was penta/oktagon shaped and was bigger than the hole - mine fit and was all round..

you can make it fit, by shaving of access rubber/plastic from it..
peejii
07-28-2003, 05:36 PM
Somebody at the WDP factory was having a bad day. The board is definately not in the right place! If you can't shift it by yourself then send it back for refitting.

p-j