PDA

View Full Version : Is the solneoid broken?

runkbulle
07-03-2003, 03:29 PM
I took my LED apart for an ano-job and when I was about to put it back together I couldn't get the solenoid to click.

I'm not sure that the wires are connected to the right places at the charging-thing in the backplate and I can't find any diagrams showing me this either. The on-off, LED and intellifeed work though.

When doing measurements on the voltage to the solenoid I get real weird values. Sometimes when not fireing the voltage jumps up and down between 0,00 to 1,00 V. When firing It's mostly between 1 and 1,5V.

Does anyone have any clues on this one?
MoogLe
07-03-2003, 03:34 PM
i dont know anything bout led's but dont u have to attach the wire to the board?
runkbulle
07-03-2003, 04:24 PM
It is attached. Everything is, but the solenoid doesn't click.
BURLEY
07-03-2003, 07:19 PM
think there is a test button on the solonoid, if you air it up and pres that button, what happnes?
MoogLe
07-04-2003, 01:24 AM
i dont think it needs to be aired up, since it's a test of the pneumatics, i'm not sure though
BURLEY
07-16-2003, 06:17 AM
yes it needs to be aired up, it must be if you want to test the pneumatics. How else can you test something that is dependable on air? :puzzled: the test button is behind the backplate.

what do you mean you don't know how to attach the wires? It can only be done in one way.

to test the electronics you can just turn the led on without air, if the led blinks if you pull the trigger, the electronics are fine...