Pressure questions

[jonnybravo408]

What input pressure should I set on my nitro tank into the Mini reg? Also what pressure should I use for my LPR and how do I read the pressures. Do I have to change these setting if I change the bolt and when I do these changes, I have to re-adjust my dwell correct? Thanks.

[IR3Ballah]

I have the same question... I have no idea how to do that stuff....lets learn together... SMART PEOPLE!!!! WHERE ARE YOU!!!!

[Prophet]

LPR on the LED I believe is still 87psi (like the LCD). As far as the output pressure of your tank to the Minireg, anywhere from 600psi to 900psi should be adequate. To read the LPR pressure, you should get an Angel Toolkit.

No, you would not have to change the LPR pressure or dwell when changing bolts, but you would have to adjust the Ram and Snap Ring (or atleast should).

[jonnybravo408]

What does adjusting the Ram and Snap Ring do and how is it done? And this is needed everytime you switch bolts?

[Prophet]

Read the manual on how to set Ram stroke and the Snap ring. And it should be done when switching bolts, because each bolt is just a little different. You don't 'have' to make those adjustments, but you could end up experiencing problems or ineffeciency if you don't.